top of page

Installation

The OXA Hunter -shooting Stabilizer is attached to the gun's sling swivel stud using the included adapter.

If the gun does not have a sling swivel stud at the bottom of the stock, the shooting rest is screwed directly to the gun stock. In this case, we recommend having the installation done by a gunsmith.

 

OXA shooting support installation

01

  • Remove the sling swivel stud adapter from the frame using the Allen key provided with the product.
    Place the gun upside down on a steady surface or mounting stand.

02

  • Push the locking pin out of the sling swivel stud adapter.

  • Place the adapter over the gun's sling swivel nut so that the thicker edge between the adapter and the locking pin hole is against the gun's stock.

  • Push the locking pin through the adapter and the sling swivel nut

  • Place the gasket against the stock by dropping it through the adapter

Installing the strap pin adapter

If the gun's sling swivel nut is so deep that the locking pin cannot be inserted, loosen the sling pin 0.5 - 2 turns. If you are unsure about the installation, we recommend having the installation done by a gunsmith.

Attaching the body part to the strap loop pin adapter

03

Place the frame on the sling swivel stud adapter and secure it with the mounting screws by lightly tightening.

NOTE! The sling swivel stud adapter or the gun may be permanently damaged if the screws are tightened too tightly.

 

If the shooting stabilizer does not fit securely to the curvature of the gun stock, the fit can be improved with a rubber strip (purchased separately). In a flat-bottomed gun, the rubber strip is installed on the center line and in a narrow gun, on the edges of the shooting stabilizer. To make installation easier, the rubber strip can be attached with, for example, double-sided tape.

04 Attaching the carrying strap

Attach the gun sling to the sling slot at the bottom of the shooting rest.

OXA shooting rest has a place for a gun sling
OXA picatinny exploded_edited.png

05 Picatinny rail installation

Push the rail piece from the front along the bottom of the mounting groove in the OXA shooting stabilizer and secure it with the included screw.

The rail fit is tight to prevent the rail from moving during use.

Picatinny accessory rail sold separately.

06 Using Spartan Precision Bipods and Tripods with OXA

With the accessory adapter that comes with the OXA you can attach the Spartan Precision Classic rifle adapter  to OXA Hunter. This allows you to use magnetic bipods and tripods made by Spartan Precision with the OXA.

bottom of page